Parabolic SAR (SAR – stop and reverse)

Parabolic SAR (SAR – stop and reverse) is a method devised by J. Welles Wilder, Jr, to find trends in market prices or securities. It may be used as a trailing stop loss based on prices tending to stay within a parabolic curve during a strong trend.

The concept draws on the idea that time is an enemy, and unless a security can continue to generate more profits over time, it should be liquidated. The indicator generally works well in trending markets, but provides “whipsaws” during non-trending, sideways phases. A parabola below the price is generally bullish, while a parabola above is generally bearish.

Calculation

The Parabolic SAR is calculated almost independently for each trend in the price. When the price is in an uptrend, the SAR appears below the price and converges upwards towards it. Similarly, on a downtrend, the SAR appears above the price and converges downwards.

At each step within a trend, the SAR is calculated ahead of time. That is, tomorrow’s SAR value is built using data available today. The general formula used for this is:

SAR(n+1) = SAR(n) + ? x (EP – SAR(n))

Where SAR(n) and SAR(n+1) represent today’s and tomorrow’s SAR values, respectively.

The extreme point, EP, is a record kept during each trend that represents the highest value reached by the price during the current uptrend — or lowest value during a downtrend. On each period, if a new maximum (or minimum) is observed, the EP is updated with that value.

The ? value represents the acceleration factor. Usually, this is set to a value of 0.02 initially. This factor is increased by 0.02 each time a new EP is recorded. In other words, each time a new EP is observed, it will increase the acceleration factor. This will then quicken the rate at which the SAR converges towards the price. To keep it from getting too large, a maximum value for the acceleration factor is normally set at 0.20, so that it never goes beyond that.

The SAR is recursively calculated in this manner for each new period. There are, however, two special cases that will modify the SAR value:

If tomorrow’s SAR value lies within (or beyond) today’s or yesterday’s price range, the SAR must be set to the closest price bound. For example, if in an uptrend, the new SAR value is calculated and it results to be greater than today’s or yesterday’s lowest price, the SAR must be set equal to that lower boundary.

If tomorrow’s SAR value lies within (or beyond) tomorrow’s price range, a new trend direction is then signaled, and the SAR must “switch sides.”
Upon a trend switch, several things happen. The first SAR value for this new trend is set to the last EP recorded on the previous trend. The EP is then reset accordingly to this period’s maximum. The acceleration factor is reset to its initial value of 0.02.

 

Trading Signals

1). To confirm that the market is trending:

Use a trend indicator, or Stop trading with the Parabolic SAR if whipsawed twice in a row and re-commence after a breakout from the chart pattern.

2). A trade is signaled when the price bars and stop levels intersect:

Go long when price meets the Parabolic SAR stop level, while short.
Go short when price meets the Parabolic SAR stop level, while long.

About the Author

has written 15907 stories on this site.

Write a Comment

Gravatars are small images that can show your personality. You can get your gravatar for free today!

You must be logged in to post a comment.

Copyright © 2012 Nine Stocks